H1MC-PI
The H1MC-PI is a motor control printed circuit board with a synchronisation option, without a power section, for example for use in opening or closing the windows or screens in horticultural greenhouses. The H1MC-PI is designed for DIN rail installation and can be used for the frequency control, standard control or control of synchronously-linked motors.
The motor can be controlled in both automatic and manual mode. When set to automatic mode the H1MC-PI receives the setpoint from the main controller (horticulture computer) via an ORION-MC. The position of the window or screen is determined using an encoder installed in the motor's gearbox. The position can also be controlled by means of time control.
The control printed circuit board is equipped with an alarm relay that can be used to generate an alarm via an extra alarm circuit in the event of any malfunctions.
Downloads
H1MC-PI
H1MC-PIAvailable documents:German downloads
German downloadsAvailable documents:English downloads
English downloadsAvailable documents:Solutions
ORION-MC
The ORION-MC is the communication interface between the horticulture computer and the IO units in...
CAN-IO-8-9
By means of the CAN-IO-8-9 it is possible to pass four open-close controls from the horticulture computer...
H1MC-230
The H1MC-230 is an IO unit to control one or more 1-phase 230V pipe motor(s) for the screening The...
H1MC-400
The H1MC-400 is an IO unit to control a 3-phase 400V motor for the aeration or the screening The unit...
H2MC-400
The H2MC-400 is an IO unit to control two 3-phase 400V motors for the aeration or the screening The...
H2MC-F-230
The H2MC-F-230 is an IO unit to control two 1-phase 230V frequency controllers for the aeration or...
H2MC-F-400
The H2MC-F-400 is an IO unit to control two 3-phase 400V frequency controllers for the aeration or...
MCR-1
The MCR-1 is a single manual control that can be connected to the H1MC IO units. This manual control...
MCR-2
The MCR-2 is a double manual control that can be connected to the H2MC IO units. This manual control...
EO128
The EO128 is an optical encoder with 128 pulses per revolution that can be used with each motor that...
Dutch downloads
Here you can download the remaining documents which are available.
English downloads
Here you can download the remaining documents which are available.
