H2MC-F-400
The H2MC-F-400 is an IO unit to control two 3-phase 400V frequency controllers for the aeration or the screening The unit is trained through the CAN-local by the ORION-MC.
The H2MC-F-400 is fitted with a power circuit-breaker and a manual control per control. The end switches for open, close and emergency stop and the encoder for the motors` position feedback are connected to the H2MC-F-400. On activation of the emergency stop, the power supply to the corresponding frequency controller is switched off.
Downloads
Dutch downloads
Dutch downloadsAvailable documents:German downloads
German downloadsAvailable documents:English downloads
English downloadsAvailable documents:Solutions
ORION-MC
The ORION-MC is the communication interface between the horticulture computer and the IO units in...
CAN-IO-8-9
By means of the CAN-IO-8-9 it is possible to pass four open-close controls from the horticulture computer...
H1MC-230
The H1MC-230 is an IO unit to control one or more 1-phase 230V pipe motor(s) for the screening The...
H1MC-400
The H1MC-400 is an IO unit to control a 3-phase 400V motor for the aeration or the screening The unit...
H2MC-400
The H2MC-400 is an IO unit to control two 3-phase 400V motors for the aeration or the screening The...
H2MC-F-230
The H2MC-F-230 is an IO unit to control two 1-phase 230V frequency controllers for the aeration or...
MCR-1
The MCR-1 is a single manual control that can be connected to the H1MC IO units. This manual control...
MCR-2
The MCR-2 is a double manual control that can be connected to the H2MC IO units. This manual control...
EO128
The EO128 is an optical encoder with 128 pulses per revolution that can be used with each motor that...
H1MC-PI
The H1MC-PI is a motor control printed circuit board with a synchronisation option, without a power...
Dutch downloads
Here you can download the remaining documents which are available.
English downloads
Here you can download the remaining documents which are available.
