ORION-MC
The ORION-MC is the communication interface between the horticulture computer and the IO units in the field, for example the H1MC. The ORION-MC communicates through the CAN-local bus with the IO units. The ORION receives the control commands from the horticulture computer and converts this into control commands to the IO units through the CAN-local bus.
With the ORION-MC it is possible to create motor groups to control the aeration and screens. Several motors can be assigned to each motor group. For example: the climate computer controls with a climate group through the ORION-MAC the aeration at the sheltered side of a separation. The ORION-MC controls through the IO units all aeration motors that belong to that climate group exactly to the desired position and reports this back to the climate computer.
It is also possible to assign with the ORION-MC motor groups for different controls so as to control the aeration and the screens such as sequential or simultaneous run, two screens on a wire bed, post-pulse control on the screens and frequency-controlled controls for aeration and screen.
Downloads
Dutch downloads
Dutch downloadsAvailable documents:German Downloads
German downloadsAvailable documents:English downloads
English downloadsAvailable documents:Solutions
CAN-IO-8-9
By means of the CAN-IO-8-9 it is possible to pass four open-close controls from the horticulture computer...
H1MC-230
The H1MC-230 is an IO unit to control one or more 1-phase 230V pipe motor(s) for the screening The...
H1MC-400
The H1MC-400 is an IO unit to control a 3-phase 400V motor for the aeration or the screening The unit...
H2MC-400
The H2MC-400 is an IO unit to control two 3-phase 400V motors for the aeration or the screening The...
H2MC-F-230
The H2MC-F-230 is an IO unit to control two 1-phase 230V frequency controllers for the aeration or...
H2MC-F-400
The H2MC-F-400 is an IO unit to control two 3-phase 400V frequency controllers for the aeration or...
MCR-1
The MCR-1 is a single manual control that can be connected to the H1MC IO units. This manual control...
MCR-2
The MCR-2 is a double manual control that can be connected to the H2MC IO units. This manual control...
EO128
The EO128 is an optical encoder with 128 pulses per revolution that can be used with each motor that...
H1MC-PI
The H1MC-PI is a motor control printed circuit board with a synchronisation option, without a power...
Dutch downloads
Here you can download the remaining documents which are available.
English downloads
Here you can download the remaining documents which are available.
